QP-HUB43-V1.0 LED sign Hub karta
The QP-HUB43-V1.0 LED sign HUB card has a 20-pin interface reference in the original listing. Use the table below to compare each signal with the documentation for your installed board.
Referenční číslo 20pinového rozhraní
Pins 1–12 carry four groups of R, G and B signals. Check pins 13–20 individually for the A, B, C, GND, CLK, OE and LAT assignments.
| Zvláštní kolík | Signálu | Sudý pin | Signálu |
|---|---|---|---|
| 1 | R1 | 2 | G1 |
| 3 | B1 | 4 | R2 |
| 5 | G2 | 6 | B2 |
| 7 | R3 | 8 | G3 |
| 9 | B3 | 10 | R4 |
| 11 | G4 | 12 | B4 |
| 13 | A | 14 | B |
| 15 | C | 16 | GND |
| 17 | CLK | 18 | GND |
| 19 | OE | 20 | LAT |
Původní fotografie na tabuli

Často kladené dotazy
What model does this HUB card page cover?
The listed model is QP-HUB43-V1.0. Compare the full model and revision on your existing board with the listing and verify the required replacement before ordering.
What should I check before ordering a replacement HUB card?
Compare the original listing’s 20-pin reference with your installed board documentation. Send the full model marking, connector orientation, and receiving card and LED module models if you need a fit check.
Žádost o výměnu šeku
Sdílejte kompletní model a revizi nainstalované desky, detailní pohledy na její označení a orientaci kabelů a modely přijímací karty a LED modulu.


Hodnocení
Nejsou žádné hodnocení.