Plastic LED Receiving Card Bracket
The LED-RCB is a plastic carrier frame for mounting a receiving card inside an LED display cabinet. Use it when assembling a cabinet or replacing a carrier that supports an existing card. Compare the two original gallery views with the bracket and receiving card in your cabinet.
Mounting Reference
| Položka | Odkaz |
|---|---|
| Produkt SKU | LED-RCB |
| Materiál | Plastová |
| Účel | Carrier frame for an LED display receiving card |
| Viditelné prvky | Raised mounting posts, side tabs and rectangular cutouts, shown in the original gallery |
| Kontroly vhodnosti | Compare the hole positions, card outline, connector clearance and cabinet mounting points |
Před objednáním zkontrolujte, zda se hodí
- Compare the receiving card’s mounting holes with the bracket posts. Measure the hole spacing center to center and note the board revision.
- Check the cabinet’s mounting points against the side tabs and allow room for the card’s plugs and cables.
- For a replacement, photograph the old bracket and the receiving card with their mounting points visible. Include a ruler in the photo if possible.
Fit depends on the actual board layout. A familiar brand name alone does not identify the mounting pattern. The listing does not give a hole-spacing drawing or a temperature rating. Confirm any required rating before selecting a bracket for that environment.
Často kladené dotazy
Can I choose this bracket by receiving card brand?
Compare the mounting holes and connector clearance on the exact receiving card model and board revision. The same brand can use different board layouts.
What should I send for a fit check?
Send the receiving card model and revision, the measured mounting-hole spacing, and photos of the card, old bracket and cabinet attachment points.
Need a Fit Check?
Share the card and bracket details with EagerLED before ordering if any mounting point is unclear. Refer to the existing store policy tab for shipping, taxes and returns.




Hodnocení
Nejsou žádné hodnocení.