Flexible LED-Module für gebogene Bildschirme: Radius, Nähte und Service

A flexible LED module follows a curved support so the visible surface can wrap around a column, form a concave backdrop or continue around a retail fixture. Begin with the radius and direction of the curve. Two modules with the same pixel pitch can have different bending limits.

1. Draw the curve at module scale

Mark whether the display faces inward or outward and identify the axis along which the module is designed to bend. Ask for the minimum permitted radius and the drawing for the exact module. Twisting the board or forcing it over a tighter frame can strain solder joints and connectors.

For a full cylinder, the visible circumference is π times its diameter. Compare that length with the module width in the bend direction. If the count is not a whole number, resolve the diameter or seam position with the supplier before fabricating the support.

2. Check mounting and the visible seam

A magnetic module needs a compatible supporting surface and alignment points. Inspect a sample joint under the intended lighting and brightness. A narrow black or bright line can result from the spacing or angle between adjacent modules even when both display the correct pixels.

Allow clearance behind the curve for data cables, power leads and connectors. Confirm that the module can be removed from the service side once the surrounding finish is in place.

3. Map content around the curve

Give the designer the unwrapped canvas dimensions in pixels and mark the physical seam. Keep a logo or a face away from the seam unless the artwork deliberately crosses it. For a stage backdrop, test the picture from the audience’s main viewing positions as well as directly in front of the centre module.

4. Häufig gestellte Fragen

(1) Can any flexible LED module bend in both directions?

Use the permitted bend axis and radius stated for that module. A flexible PCB can still have an unsupported direction or a restricted concave or convex radius.

(2) Will a flexible module work outdoors?

Check the environmental rating of the assembled screen, including the rear enclosure and connectors. Flexibility describes the mechanical design.

(3) Can I replace one section of a curved wall?

That depends on mounting and service access. Keep a matched spare and its configuration, and demonstrate removal of a module at the tightest part of the curve.

5. Fazit

Approve the curve with a full-size sample joint. It lets the fabricator check radius and cable clearance while the content team checks pixel alignment and the appearance of the seam.

Schreiben Sie bitte einen Kommentar.