How to Size an LED Screen Power Supply for a Cabinet

Start with the module’s required DC voltage and maximum current. A supply can have the right wattage and still be unsuitable because its output voltage, usable current at cabinet temperature or physical connections differ.

1. Calculate the load on each DC rail

Example load calculation for one low-voltage DC rail
Input to the calculationValor de ejemploResultado
Voltaje de funcionamiento del módulo5 V DCAll modules on this example rail require 5 V
Maximum current per module4 AUse maximum current from the specific module data sheet
Modules on the rail66 × 4 A = 24 A
Maximum module load5 V × 24 A120 W before other loads or design allowance

These numbers illustrate the method. Replace them with the installed module ratings and include the receiving card, hub and any other devices supplied by the same rail. For mixed loads, add the currents on each voltage rail separately. Keep the design allowance specified for the cabinet.

2. Check the power available inside the cabinet

A supply’s label rating applies under stated conditions. Read the temperature derating curve for the planned operating temperature and cooling arrangement. A supply installed close to a warm rear cover may have less usable output than its headline wattage suggests.

For the example above, a unit rated exactly 120 W has no allowance for the receiving electronics or temperature derating. Select the exact model only after those loads and conditions are known.

3. Match the replacement to the existing installation

Record the old part number, input range, DC voltage, rated current, dimensions, fixing-hole pattern and terminal positions. Check polarity against the cabinet drawing. Have a qualified technician isolate the cabinet and verify the replacement under the manufacturer’s procedure.

If a South Creative or other supply lists short-circuit or overtemperature protection, read how that model recovers after a fault. Protection features, airflow requirements and warranty terms are model-specific.

4. Preguntas frecuentes

(1) Can I replace a 5 V supply with a 12 V unit of equal wattage?

The replacement must supply the voltage specified for the modules. Applying a higher voltage can damage the electronics.

(2) Should I size a supply from average screen consumption?

Use the maximum supported load and the cabinet manufacturer’s design conditions for sizing. Average consumption describes operation with a particular brightness and content mix.

(3) Is a higher-current supply always a drop-in replacement?

Check the voltage, connectors, protection, usable current, input characteristics and mounting. The branch wiring and distribution hardware also have limits.

5. Conclusión

Keep a short load schedule for each cabinet. With the DC voltage, maximum current and derated output on one sheet, a technician can evaluate a replacement before it reaches the screen.

Deje un comentario