نمایشگرهای LED اجاره‌ای P3.91: کابینت‌های ۵۰۰ × ۵۰۰ در مقابل ۵۰۰ × ۱۰۰۰ میلی‌متر

نمایشگر LED اجاره ای 500x500mm 500x1000mm P3.91

P3.91 describes the nominal spacing between adjacent pixel centres. The 500 × 500 mm and 500 × 1000 mm measurements describe cabinet dimensions. A taller cabinet can reduce the number of cabinet joints in a wall without increasing its pixel density.

1. Calculate the cabinet count and native canvas

کابینت نمایشگر LED اجاره‌ای
LED display module used to illustrate pixel pitch
Example P3.91 cabinet layout at 3.90625 mm actual pitch
Cabinet faceTypical pixel matrix in this exampleCabinets for a 4 m × 2 m wall
500 × 500 میلیمتر128 × 128۳۰ در عرض × ۱۲ در ارتفاع = ۳۶۰
500 × 1000 میلیمتر128 × 256۳۰ در عرض × ۱۲ در ارتفاع = ۳۶۰

Both layouts in the example produce a 1024 × 512 pixel canvas. Confirm the actual cabinet matrix on the rental inventory before sending the artwork template to a designer. The video below illustrates the equipment discussed in the original guide.

2. Select the cabinet for the venue

(1) Outdoor use

Outdoor LED module illustrated in the rental guide

Ask for the rated protection of the front and rear, the specified brightness and the connector protection required when assembled. A roof over the stage can still leave the rear of a wall exposed to wind-driven rain.

(2) Indoor use

Indoor LED module illustrated in the rental guide

Check the lowest usable brightness with the show content. For an event recorded on camera, rehearse at the intended brightness, camera position and shutter settings. Pixel pitch alone cannot predict the camera result.

(3) GOB modules

LED module with a glue-on-board protective surface

Glue-on-board describes a protective layer on the module face. Check the finished cabinet’s environmental rating and repair procedure separately.

3. Compare handling and service access

Rental cabinet layout
Rental cabinet service features
Modular rental LED display

A larger cabinet covers more area per lift. Ask for the weight of the fully equipped cabinet, the case packing plan and the permitted handling method. Confirm access to modules, power supplies and receiving cards after the wall is assembled.

4. Specify the support system and wall shape

Rental screen support bracket
Hanging beam for a rental LED wall

Ground-stacked and suspended walls require the manufacturer’s compatible hardware and a load plan approved for the venue. Supply the crew with the exact cabinet series, dimensions and layout when requesting the rigging design.

Curved rental cabinet arrangement
Right-angle rental LED cabinet joint

For a curved wall or a 90-degree corner, specify the joint angle and edge geometry. Look at a sample seam displaying a diagonal line before accepting the layout.

5. سوالات متداول

(1) Can 500 × 500 and 500 × 1000 mm cabinets be mixed?

Only when the manufacturer confirms mechanical, electrical and pixel alignment compatibility between the specific cabinets. Check locks, module matrix and calibration as a set.

(2) Does P3.91 tell me whether a screen can be used outdoors?

It describes pixel pitch. Outdoor use depends on the cabinet rating, connectors, mounting system and conditions at the site.

(3) Which size is better for a low stage opening?

Draw the available height in 500 mm increments, including clearance for support hardware. A 500 mm high cabinet gives an extra row-height option when a 1000 mm unit would be too tall.

6. نتیجه

Choose cabinet height from the wall drawing and handling plan. Then verify the signed-off pixel matrix, environmental rating and mounting hardware against the actual rental stock.

پاسخ دهید