Le EagerLED X-01 uses suction to lift a compatible front-service LED module out of its cabinet. Before using it, identify how the module is retained and how much clearance its cables allow. A module secured by screws or a cable tether needs the cabinet’s own removal procedure.
1. Check the module and battery

Isolate cabinet power according to its service instructions. Inspect the suction surface, check the tool’s charge and arrange a place to support the module once it comes free. The X-01 indicator guide describes green as full, yellow as roughly 25–75% and red as below 25%.
2. Remove a compatible front-service module
Hold the handle, switch on the main power and centre the suction cup on the module face. Tap the touch switch to start the motor. Once the cup has a secure hold, draw the module straight out with a gentle, steady motion. Stop if it resists or the cup loses its seal.
Support the released module with your free hand before tapping the touch switch to stop the motor. Switch off the main power. Keep the module supported while dealing with any cables or retaining hardware specified by the cabinet manufacturer.
3. Charge the X-01
| Produit | Valeur publiée | Comment l'utiliser |
|---|---|---|
| Charger AC input | 100-240 V | Check the supplied charger label before connecting it |
| Charger DC output | 25.2 V, A 1 | Use the charger specified for the tool |
| Énergie de la batterie | 43.2 Wh | Distinguish battery capacity from charger output |
| Décharge continue | 12 minutes in the stated laboratory test | Plan charging breaks according to the actual battery condition |
Follow the charging instructions for the supplied stand: connect the specified charger to the stand and AC supply, place the tool in its charging position and use the main switch and battery indicator as directed on the tool. Switch off and disconnect the charger once charging is complete. Before storing the tool, follow its battery maintenance instructions.
4. Questions fréquentes
(1) Can the X-01 remove any LED module from the front?
Check that the module supports vacuum front service and that its face is suitable for the cup. Release any mechanical retainers required by the cabinet design first.
(2) What should I do if the cup will not hold?
Support the module, stop the motor and inspect the contact surfaces and battery indication. Recheck the service method before trying again. Pulling harder can damage the module face.
(3) Does a 12-minute rating mean 12 minutes on every charge?
The published figure is a continuous-discharge laboratory result. Battery age, temperature and operating conditions affect the time available in service.
5. Conclusion
Centre the cup, support the module as it releases and stop the motor only when the module is secure. For a replacement charger, match the X-01 label and stand to the X-01 product details.

