LED video procesory: Škálování, přepínání zdrojů a mapování pixelů

LED Video Processor

An LED video processor fits incoming video to the pixel layout of an LED wall. It is especially useful when a laptop, camera or media player must share one screen, or when the wall has a different aspect ratio from the source.

1. Fit the source to the LED canvas

Consider a 1,920 × 1,080 presentation on a 1,920 × 640 banner. Preserving the entire slide at its original proportions leaves unused space on the sides. Filling the banner at the correct proportions crops the top and bottom. A banner-sized export gives the designer control over every pixel. Check small text and logos before choosing a scaling mode.

2. Switch inputs and recall layouts

For a live event, list the sources and their actual output timings. Confirm the processor accepts each signal, then test the transition between the presentation laptop and the camera while both are connected. If the show needs a camera inset or a backup slide, check the supported layer count and whether presets recall the required source and position.

3. Match the processor to the sending system

A standalone processor feeds a sending device. An all-in-one controller combines processing and sending. Check which unit drives the receiving cards, the wall’s total pixel count, the longest row and the load assigned to each output. An HDMI input resolution alone tells you little about the LED wall size the sending system can drive.

During commissioning, show a one-pixel border and a grid with labeled corners. Missing edges point to cropping or an incorrect canvas size. A cabinet showing the wrong part of an otherwise complete image calls for a mapping check.

4. závěr

Choose the signal path around the sources, the wall’s native dimensions and the layouts the operator will use. A test with actual slides and camera feeds reveals cropping and switching problems before the audience sees them.

5. Často kladené otázky

(1) Will a video processor make my LED screen brighter?

The modules, power and drive settings determine the wall’s available light output. Signal adjustments can change how an image looks, but they cannot raise the panel’s rated brightness.

(2) Do I need a separate processor if my controller has scaling?

A controller may already cover the job. Check its inputs, scaling modes, layer count and switching behavior against the show requirements.

(3) Why do circles look oval on my LED wall?

The source has probably been stretched to a canvas with a different aspect ratio. Use proportional scaling, crop deliberately or create content at the native wall dimensions.

(4) How do I keep fine text sharp?

Design at the wall’s native pixel size where practical, use pixel-to-pixel mapping for that source and check a sample at the audience’s viewing distance.

Napsat komentář