P3.91 describes the nominal spacing between adjacent pixel centres. The 500 × 500 mm and 500 × 1000 mm measurements describe cabinet dimensions. A taller cabinet can reduce the number of cabinet joints in a wall without increasing its pixel density.
1. Calculate the cabinet count and native canvas


| Bagian depan kabinet | Typical pixel matrix in this example | Cabinets for a 4 m × 2 m wall |
|---|---|---|
| 500 × 500 mm | × 128 128 | 8 lebar × 4 tinggi = 32 |
| 500 × 1000 mm | × 128 256 | 8 lebar × 2 tinggi = 16 |
Both layouts in the example produce a 1024 × 512 pixel canvas. Confirm the actual cabinet matrix on the rental inventory before sending the artwork template to a designer. The video below illustrates the equipment discussed in the original guide.
2. Select the cabinet for the venue
(1) Outdoor use

Ask for the rated protection of the front and rear, the specified brightness and the connector protection required when assembled. A roof over the stage can still leave the rear of a wall exposed to wind-driven rain.
(2) Indoor use

Check the lowest usable brightness with the show content. For an event recorded on camera, rehearse at the intended brightness, camera position and shutter settings. Pixel pitch alone cannot predict the camera result.
(3) GOB modules

Glue-on-board describes a protective layer on the module face. Check the finished cabinet’s environmental rating and repair procedure separately.
3. Compare handling and service access



A larger cabinet covers more area per lift. Ask for the weight of the fully equipped cabinet, the case packing plan and the permitted handling method. Confirm access to modules, power supplies and receiving cards after the wall is assembled.
4. Specify the support system and wall shape


Ground-stacked and suspended walls require the manufacturer’s compatible hardware and a load plan approved for the venue. Supply the crew with the exact cabinet series, dimensions and layout when requesting the rigging design.


For a curved wall or a 90-degree corner, specify the joint angle and edge geometry. Look at a sample seam displaying a diagonal line before accepting the layout.
5. Pertanyaan yang sering diajukan
(1) Can 500 × 500 and 500 × 1000 mm cabinets be mixed?
Only when the manufacturer confirms mechanical, electrical and pixel alignment compatibility between the specific cabinets. Check locks, module matrix and calibration as a set.
(2) Does P3.91 tell me whether a screen can be used outdoors?
It describes pixel pitch. Outdoor use depends on the cabinet rating, connectors, mounting system and conditions at the site.
(3) Which size is better for a low stage opening?
Draw the available height in 500 mm increments, including clearance for support hardware. A 500 mm high cabinet gives an extra row-height option when a 1000 mm unit would be too tall.
6. Kesimpulan
Choose cabinet height from the wall drawing and handling plan. Then verify the signed-off pixel matrix, environmental rating and mounting hardware against the actual rental stock.

