Static Drive vs. Scan Drive in LED Displays

A static-drive module gives each LED channel its own drive path. A scan-drive module shares driver outputs across groups of LEDs and selects each group in turn. Both can show a still image or moving video. The distinction describes how the module lights its pixels.

1. What a scan ratio tells you

In a 1/8-scan design, a group has one turn in an eight-step selection cycle. Several parts of a module may scan in parallel. The fraction alone does not tell you how many physical rows light across the whole cabinet.

How static and multiplexed drive compare
AntriebsschemaWhat happens during a selection cycle
Static (1/1)No row-sharing interval. The driver can still pulse a channel to control its grayscale level.
1 / 8 ScanEach group has up to one eighth of the selection time, before dimming and blanking intervals.
1 / 16 ScanEach group has up to one sixteenth of the selection time. The driver and module layout determine the sequence.

2. Brightness, refresh rate and camera banding

With the same LED and peak current, a shorter on-time reduces average light output. Finished modules can use different LEDs, current settings and drive timing. Compare their specified brightness at the intended operating conditions. An outdoor installation alone does not identify the scan ratio.

Outdoor LED billboard showing a video image above a street

Refresh rate is measured in hertz. Scan ratio is a fraction. A camera can record bands when its exposure samples the display’s light pulses unevenly. Compare a test recording at the intended brightness, frame rate and shutter setting before choosing a panel for filming.

3. How to identify a replacement module

Read the module model and board revision, then check the specified scan ratio, driver IC, pinout and receiving-card configuration. A repeating or scrambled row pattern after a swap is a reason to check mapping and configuration before accepting the replacement.

4. Fazit

Use the scan ratio to identify the drive arrangement and match replacement hardware. For screen selection, compare measured brightness and check motion and camera performance under the conditions in which the screen will operate.

5. Häufig gestellte Fragen

(1) Does 1/16 scan mean a refresh rate of 16 Hz?

No. It describes one group’s share of the selection cycle. Look for a separate refresh-rate figure in hertz.

(2) Is a 1/8-scan panel always brighter than a 1/16-scan panel?

A longer selection interval can help if other conditions match. For two finished products, compare brightness specifications or measurements at the same settings.

(3) Can I replace a 1/8-scan module with a 1/16-scan module of the same size?

Matching dimensions do not establish compatibility. Check the receiving-card configuration, row addressing, driver and pinout against the exact replacement board.

Schreiben Sie bitte einen Kommentar.